Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2002CAVALIER BASE, 4D SEDAN, 2.2 4, LN2, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESTRACTION CONTROLANTI-LOCK BRAKE SYSTEMREPAIR INSTRUCTIONSELECTRONIC BRAKE CONTROL MODULE (EBCM) REPLACEMENTINSTALLATION PROCEDURE
2002 Chevrolet Cavalier Base, 4D Sedan, 2.2 4, LN2, Standard
Installation Procedure
2002 Chevrolet Cavalier Base, 4D Sedan, 2.2 4, LN2, StandardSECTION Installation Procedure
- Clean the EBCM gasket and the BPMV surface with alcohol using a clean rag.
- Install the EBCM (1) to the BPMV (2).NOTE: Refer to Fastener Notice in Cautions and Notices.
- Install the four screws that attach the EBCM (1) to BPMV (2).
Tighten
Tighten the four screws to 5 N.m (44 lb in).
- Connect the EBCM harness connector (4).
- Push down the harness connector lock tab and then move the sliding connector cover back in the home position to lock.
- Push the CPA (2) back into place.
- Perform the Diagnostic System Check. Refer to DIAGNOSTIC SYSTEM CHECK - ABS .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.