Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2002CAVALIER BASE, 4D SEDAN, 2.2 4, LN2, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTIGNITION SWITCH/STEERING LOCKSTEERING WHEEL & STEERING COLUMNREMOVAL & INSTALLATIONIGNITION SWITCH REPLACEMENT - ON VEHICLEINSTALLATION PROCEDURE
2002 Chevrolet Cavalier Base, 4D Sedan, 2.2 4, LN2, Standard
Installation Procedure
2002 Chevrolet Cavalier Base, 4D Sedan, 2.2 4, LN2, StandardSECTION Installation Procedure
- Install the ignition switch (3) to the steering column (1).
- Install the retaining screws (2) to the ignition switch (3). Tighten the screws to 4 N.m (36 lb in).
- Install the ignition lock cylinder.
- Install the steering column trim covers.
- Connect the negative battery cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.