Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Powertrain Control Module
Cruise Control Module (CCM) sends a signal to the Powertrain Control Module (PCM) through cruise engaged output terminal when cruise control is activated. The CCM cruise inhibit input terminal is a circuit used by the PCM to inhibit cruise control when conditions inconsistent with cruise operation are present. If the PCM determines that any of the cruise control inhibit conditions are present, the PCM requests that CCM suspend cruise control operation. The PCM accomplishes this request by opening the cruise inhibit output circuit. If the cruise engage output signal, sent by the CCM to the PCM, indicates that the cruise control is still engaged after the PCM has requested that cruise control disengage, the PCM sets a DTC. The PCM will inhibit cruise control under following conditions:
- Engine not running long enough for cruise control operation.
- Automatic transaxle is in Park, Reverse, Neutral or 1st gear.
- Manual transaxle is in Neutral.
- Engine speed is too high/low.
- Vehicle speed is too high/low.
- Anti-lock brake system/traction control system is active for greater than 2 seconds.
- Undercharged or overcharged battery condition exists.
- Vehicle acceleration/deceleration rate is too high.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.