Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2002CAMARO SS, 2D COUPE, STANDARDREPAIR AND DIAGNOSISENGINE MECHANICALENGINE EXHAUST SYSTEMREPAIR INSTRUCTIONSEXHAUST HANGER REPLACEMENT (3.8 AND 5.7L ENGINES - LEFT SIDE)INSTALLATION PROCEDURE

2002 Chevrolet Camaro SS, 2D Coupe, Standard

Installation Procedure

2002 Chevrolet Camaro SS, 2D Coupe, StandardSECTION Installation Procedure

NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

Install the exhaust muffler hanger bolts.

Fig 1: Installing Exhaust Muffler Hanger Bolts
Courtesy of GENERAL MOTORS CORP.

Tighten

Tighten the exhaust muffler hanger bolts to 10 N.m (89 Inch lbs).
Install the exhaust muffler hanger insulator.
Allow the exhaust to be support by the insulator.
Remove the adjustable jack stand.
Lower the vehicle.

Fig 2: Installing Exhaust Muffler Hanger Insulator
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.