Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC 44: Body Control Module With Encryption Error: Description
A digital Radio Frequency (RF) message received was from a remote transmitter that is programmed to Body Control Module (BCM), but message did not pass encryption security test. No remote function capabilities will exist. DTC 44 will set when remote transmitter has been in program or synchronize mode while out of range of BCM. Fault may also be present if digital RF message has an error. Most likely cause is that remote transmitter is out of synchronization.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.