SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2002AVALANCHE 2500, RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 993 (KEYLESS ENTRY SYSTEM)REPAIR INSTRUCTIONSREMOTE CONTROL DOOR LOCK RECEIVER REPLACEMENTINSTALLATION PROCEDURE
2002 Chevrolet Avalanche 2500, RWD

Installation Procedure

2002 Chevrolet Avalanche 2500, RWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Position the remote control door lock receiver to the defroster air duct.
  1. Install the remote control door lock receiver (2).
  2. Engage the remote control door lock receiver retainers.
  3. Connect the remote control door lock receiver electrical connector (1).
  4. Install the upper trim pad. Refer to Trim Pad Replacement - Instrument Panel (I/P) Upper (Aztek) or Trim Pad Replacement - Instrument Panel (I/P) Upper (Rendezvous) in Instrument Panel, Gages and Console.
    Fig 1: Upper I/P Trim Panel Location View
    GM629215Courtesy of GENERAL MOTORS CORP.
  5. If a new remote control door lock receiver is being installed, program the transmitter. Refer to Transmitter Programming .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.