Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSCHEVROLET2002AVALANCHE 2500, RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 690 (SECURITY SYSTEM AND LOCKS SYSTEM)
2002 Chevrolet Avalanche 2500, RWD
Section 690 (Security System And Locks System)
2002 Chevrolet Avalanche 2500, RWDSECTION Section 690 (Security System And Locks System)
WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
- Security And Locks Location Index
- Front Outer Handle Removal/Installation
- Rear Outer Handle Removal/Installation
- Inner Handle Removal/Installation
- Front Door Key Cylinder Removal/Installation
- Front Door Latch And Lock Actuator Removal/Installation
- Rear Door Latch And Lock Actuator Removal/Installation
- Front Door Latch And Lock Actuator Inspection
- Rear Door Latch And Lock Actuator Inspection
- Front Door Lock Actuator Inspection
- Rear Door Lock Actuator Inspection
- Front Door Latch Switch Inspection
- Rear Door Latch Switch Inspection
- Door Lock-Link Switch Inspection
- Front Door Key Cylinder Switch Inspection
- Door Lock Switch Removal/Installation
- Door Lock Switch Inspection
- Door Lock Striker Removal/Installation
- Fuel-Filler Lid Opener Removal/Installation
- Hood Latch And Release Lever Removal/Installation
- Hood Latch Switch Inspection
- Keyless Control Module Removal/Installation
- Keyless Control Module Inspection
- Transmitter Battery Replacement
- Transmitter Battery Inspection
- Transmitter Id Code Registration
- Trunk Lid Latch Removal/Installation
- Trunk Lid Opener Removal/Installation
- Trunk Lid Latch Switch Inspection
- Trunk Lid Key Cylinder Removal/Installation
- Trunk Lid Key Cylinder Switch Inspection
- Trunk Lid Lock Striker Removal/Installation
- Liftgate Outer Handle Removal/Installation
- Liftgate Latch And Lock Actuator Removal/Installation
- Liftgate Lock Actuator Inspection
- Liftgate Latch Switch Inspection
- Liftgate Lock Striker Removal/Installation
- Coil Antenna Removal/Installation
- Immobilizer System Component Replacement/Key Addition And Clearing
- Foreword
- No. 1 Additional Key Registration Procedure (Using Two Valid Keys)
- No. 2 Additional Key Registration Procedure (Using The WDS Or Equivalent)
- No. 3 Key Replacement Procedure (Clearing Previously Registered Key Id Numbers, Key Re-Registration)
- No. 4 Changing The Method For Registering Additional Keys
- No. 5 Resetting Procedure For The Immobilizer System When Replacing The Pcm Or Instrument Cluster
- No. 6 Security Access Procedure
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.