SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2002AVALANCHE 2500, RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 643 (CRUISE CONTROL SYSTEM)REPAIR INSTRUCTIONSCRUISE CONTROL MODULE REPLACEMENTINSTALLATION PROCEDURE
2002 Chevrolet Avalanche 2500, RWD

Installation Procedure

2002 Chevrolet Avalanche 2500, RWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the module assembly to the mounting bracket.
  2. Connect the electrical connector to the module.
    Fig 1: Installing Cruise Control Module
    G01780018Courtesy of GENERAL MOTORS CORP.
  3. Connect the cruise control cable to the module ribbon.
    Fig 2: Connecting Cruise Control Cable To Ribbon
    G01780019Courtesy of GENERAL MOTORS CORP.
  4. Install the cruise control cable to the module assembly by turning the cable assembly 1/4 turn clockwise.
    Fig 3: Installing Cruise Control Cable To Module
    G01780020Courtesy of GENERAL MOTORS CORP.
  5. Install the cruise control cable tab (5) to the throttle body cam (6).
  6. Align the cruise control cable fitting to the throttle body bracket (1). Snap the fitting into place. Ensure that the fitting is retained.
  7. Close the hood.
  8. Perform A Diagnostic System Check. Refer to Diagnostic System Check - Cruise Control .
    Fig 4: Connecting Cruise Control Cable
    G01780021Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.