Installation Procedure

2002 Chevrolet Avalanche 2500, RWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the cruise control module to the vehicle.
  2. Connect the cruise control cable to the cruise control module. Refer to Cruise Control Cable Replacement (4.3L Engine)  or Cruise Control Cable Replacement (4.8L, 5.3L & 6.0L Engines)  .
  3. Install the nuts in order to retain the cruise control module to the cowl. Tighten the nuts to 9 N.m (80 lb in).
  4. Connect the electrical connector at the cruise control module.
  5. Install the brace. Tighten the bolts to 9 N.m (80 lb in).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.