Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2002AVALANCHE 2500, RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 231 (BODY CONTROL MODULES)INTERMITTENTSTEST PROCEDURESINTERMITTENT SIMULATION
2002 Chevrolet Avalanche 2500, RWD
Intermittent Simulation
2002 Chevrolet Avalanche 2500, RWDSECTION Intermittent Simulation
WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
Attempt to reproduce conditions causing intermittent problem(s):
- Apply light vibration to components.
- Apply small amount of heat to component.
- Wiggle or bend wiring harness.
- Remove/apply vacuum supply source.
Monitor circuit/component voltage or resistance while attempting to simulate intermittent. Monitor for DTCs. Use test results to identify problem component or circuit.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.