Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2002AVALANCHE 2500, RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 18 (BODY CONTROL MODULES)DIAGNOSTIC TESTSDTC B1000: BODY CONTROL MODULE INTERNAL FAULTTESTING
2002 Chevrolet Avalanche 2500, RWD
DTC B1000: Body Control Module Internal Fault: Testing
2002 Chevrolet Avalanche 2500, RWDSECTION Testing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2002 GMC Savana, 2002 Chevrolet Chevy Express, 2001 GMC Savana Special, 2001 GMC Savana Camper Special, and 2001 GMC Savana. However, it is still accessible from the selected car via links, so may be relevant.
- If appropriate diagnostic system check has been performed for system exhibiting symptom, go to next step. If appropriate diagnostic system check has not been performed for system exhibiting symptom, perform appropriate diagnostic system check. See DIAGNOSTIC SYSTEM CHECK table under SELF-DIAGNOSTIC SYSTEM.
- Turn ignition switch to OFF position. Connect scan tool to Data Link Connector (DLC), located below steering column. Turn ignition switch to RUN position. Retrieve DTCs. If DTC B1004 is retrieved as a current DTC, go to next step. If DTC B1004 is not retrieved as current, go to DIAGNOSTIC AIDS .
- Replace appropriate module. After repair, go to next step.
- Using scan tool, clear DTCs. Operate vehicle within conditions for running the DTC as specified in supporting text. If DTC resets, go to step 2 .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.