Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2002AVALANCHE 2500, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESTRACTION CONTROLANTI-LOCK BRAKE SYSTEMREPAIR INSTRUCTIONSTRACTION CONTROL SWITCH REPLACEMENT (TRACTION CONTROL)REMOVAL PROCEDURE
2002 Chevrolet Avalanche 2500, RWD
Removal Procedure
2002 Chevrolet Avalanche 2500, RWDSECTION Removal Procedure
- Remove Instrument Panel (IP) bezel. Refer to BEZEL REPLACEMENT - IP CLUSTER in Instrument Panel, Gauges and Console.
- Gently lift the switch retaining tabs (1) and remove the traction control switch (2) from the Instrument Panel (IP) assembly (3).
- Disconnect the harness connector from the traction control switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.