Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2002AVALANCHE 2500, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTHEADLIGHTSLIGHTING SYSTEMSREPAIR INSTRUCTIONSTAIL/TURN SIGNAL LAMP REPLACEMENTREMOVAL PROCEDURE
2002 Chevrolet Avalanche 2500, RWD
Removal Procedure
2002 Chevrolet Avalanche 2500, RWDSECTION Removal Procedure
- Ensure that the headlamp switch is in the OFF position.
- Open the endgate.
- Avalanche model shown.
Remove the 2 screws retaining the tail/turn signal lamp assembly to the body.
- Identify the bulb in need of replacement.
- The top bulb is a parking lamp and stop lamp
- The center bulb is a turn indicator lamp
- The lower bulb is a backup lamp
- Rotate the bulb socket 1/4 turn counter-clockwise in order to remove the bulb sockets from the tail/turn lamp assembly.
- Remove the bulbs from the sockets by pulling out the bulbs.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.