Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2002AVALANCHE 1500 2WD V8-5.3L VIN TREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - BODY AND FRAMEPOWER MIRROR CONTROL MODULESERVICE AND REPAIRACCESSORY AND OUTSIDE REAR VIEW MIRROR MODULE REPLACEMENT
2002 Chevrolet Avalanche 1500 2WD V8-5.3L VIN T
Accessory and Outside Rear View Mirror Module Replacement
2002 Chevrolet Avalanche 1500 2WD V8-5.3L VIN TSECTION Accessory and Outside Rear View Mirror Module Replacement
REMOVAL PROCEDURE
1. Remove the drivers side door panel.
2. Remove the screws (1) that retain the accessory and outside rear view mirror module from the door panel.
3. Remove the nut (2) that retains the accessory and outside rear view mirror module from the door panel.
4. Remove the module from the door panel.
INSTALLATION PROCEDURE
1. Install the module to the door panel.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the nut (2) that retains the accessory and outside rear view mirror module to the door panel.
Tighten
Tighten the module retaining nut to 0.6 N.m (5 lb in).
3. Install the screws (1) that retain the accessory and outside rear view mirror module to the door panel.
Tighten
Tighten the module retaining screws to 0.6 N.m (5 lb in).
4. Install the drivers door panel.
5. Perform the memory mirror module learn procedure. Testing and Inspection
1. Remove the drivers side door panel.
2. Remove the screws (1) that retain the accessory and outside rear view mirror module from the door panel.
3. Remove the nut (2) that retains the accessory and outside rear view mirror module from the door panel.
4. Remove the module from the door panel.
INSTALLATION PROCEDURE
1. Install the module to the door panel.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the nut (2) that retains the accessory and outside rear view mirror module to the door panel.
Tighten
Tighten the module retaining nut to 0.6 N.m (5 lb in).
3. Install the screws (1) that retain the accessory and outside rear view mirror module to the door panel.
Tighten
Tighten the module retaining screws to 0.6 N.m (5 lb in).
4. Install the drivers door panel.
5. Perform the memory mirror module learn procedure. Testing and Inspection
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.