Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001VENTURE BASE, VAN CARGO EXTENDEDREPAIR AND DIAGNOSISGENERAL INFORMATIONCOMPUTER RELEARN PROCEDURESGENERAL MOTORS (TRUCKS & VANS)CUTAWAY, EXPRESS, RV CUTAWAY & SAVANAPOWERTRAIN CONTROL MODULE (PCM) PROGRAMMING (6.5L DIESEL)
2001 Chevrolet Venture Base, Van Cargo Extended
Powertrain Control Module (PCM) Programming (6.5L Diesel)
2001 Chevrolet Venture Base, Van Cargo ExtendedSECTION Powertrain Control Module (PCM) Programming (6.5L Diesel)
- If PCM was replaced, PCM must be programmed. If PCM is not programmed, a DTC will be set.
- Ensure battery is fully charged. Ensure cable at Data Link Connector (DLC) and power supply for scan tool are properly connected. Turn ignition switch to ON position. Perform EEPROM programming using Techline® equipment manufacturer's instructions and latest software applicable for the vehicle model.
- Perform password learn procedure for anti-theft system. See PASSWORD LEARN PROCEDURE FOR ANTI-THEFT SYSTEM (6.5L DIESEL) . Once PCM is programmed, if only the PCM was replaced, go to next step. If crankshaft position sensor, engine or PCM with fuel injection pump were replaced, perform TDC offset learn procedure. See TDC OFFSET LEARN PROCEDURE (6.5L DIESEL) .NOTE: If PCM programming fails, ensure all electrical connections on PCM are okay. Check Techline® for latest software. If EEPROM programming still fails, replace PCM.
- Start and warm engine until engine coolant temperature is at least 170°F (77°C). This will allow TDC offset to be programmed into the PCM if necessary. PCM has the ability to determine amount of offset required to bring engine to TDC. PCM uses TDC to determine proper fuel injection pump timing. If TDC offset is not programmed, DTC P1214 will be set.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.