Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2001SUBURBAN C1500REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 3 (TRANSFER CASE - NVG 236/246-NP8 (TWO SPEED AUTOMATIC) - SERVICE, REPAIR AND DIAGNOSTICS)REPAIR INSTRUCTIONSTRANSFER CASE SPEED SENSOR REPLACEMENT (FRONT)REMOVAL PROCEDURE

2001 Chevrolet Suburban C1500

Removal Procedure

2001 Chevrolet Suburban C1500SECTION Removal Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: Front Speed Sensor Electrical Connector

Courtesy of GENERAL MOTORS COMPANY

Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
Remove the transfer case shield. Refer to Transfer Case Shield Replacement .
Remove the transfer case front speed sensor electrical connector.

Fig 2: View Of Vehicle Speed Sensor

Courtesy of GENERAL MOTORS COMPANY

Remove the transfer case front speed sensor.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.