Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Power Take Off (PTO) Switch
2001 Chevrolet Suburban C1500SECTION Power Take Off (PTO) Switch
WARNING: This page is about a different variant/trim than selected.
Power Take Off (PTO) Switch
| Connector Part Information |
|
||
|---|---|---|---|
| Pin | Wire Color | Circuit No. | Function |
| A | BRN | 41 | Ignition 3 Voltage |
| B | LT GRN | 488 | Power Take Off (PTO) relay Switched Enable Control |
| C | GRY | 8 | Instrument Panel Lamp Supply Voltage - 1 |
| D | GRY | 397 | Cruise Control On Switch Signal |
| E | YEL | 2522 | Power Take Off (PTO) Status |
| F | BLK | 1850 | Ground |
| G | DK BLU | 84 | Cruise Control Set/Coast Switch Signal |
| H | PPL/WHT | 1382 | LED Dimming Signal |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.