GM SPO Group Numbers

2001 Chevrolet Suburban C1500SECTION GM SPO Group Numbers
WARNING: This page is about a different variant/trim than selected.
GM SPO Group Numbers

Application GM SPO Group Number
Accelerator Pedal 3.451
Air Cleaner Assembly 3.402
Air Filter 3.410
Camshaft Position (CMP) Sensor 2.383
Crankshaft Position (CKP) Sensor 2.383
Engine Coolant Level Switch 1.203
Engine Coolant Temperature (ECT) Sensor 3.682
Engine Oil Level Sensor 1.516
Engine Oil Pressure Sensor 1.800
EVAP Canister 3.130
EVAP Fuel Tank Pressure Sensor 3.140
EVAP Hoses and Pipes 3.145
EVAP Purge Solenoid 3.140
EVAP Vent Valve 3.140
Exhaust Gas Recirculation (EGR) Valve 3.670
Fuel Hoses and Pipes 3.163
Fuel Injectors 3.300
Fuel Pump 3.900
Fuel Pump Relay 3.900
Fuel Rail Assembly 3.330
Fuel Sender 3.107
Fuel Tank 3.001
Fuel Tank Straps 3.022
Heated Oxygen Sensor 3.682
Ignition Coil 2.170
Inline Fuel Filter 3.890
Intake Air Duct 3.417
Intake Air Temperature (IAT) Sensor 3.682
Knock Sensors 2.383
Manifold Absolute Pressure (MAP) Sensor 3.682
Mass Air Flow (MAF) Sensor 3.682
Positive Crankcase Vent Valve 1.745
Powertrain Control Module (PCM) 3.670
Secondary Air Injection Hoses/Pipes and Check Valves 3.670-3.675
Secondary Air Injection Pump 3.660
Secondary Air Injection Pump Relay 3.682
Secondary Air Injection Solenoid 3.670
Secondary Air Injection Shut Off Valve 3.670
Throttle Body Assembly 3.335
Throttle Position (TP) Sensor 3.339
Vehicle Speed (VSS) Sensor 3.682
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.