Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
- Install the sight shield bracket, if necessary.
Refer to FASTENER NOTICE in Cautions and Notices.
- Install the sight shield bracket nuts, if necessary.
Tighten
Tighten the intake manifold sight shield bracket nuts to 5 N.m (44 lb in).
- Install the intake manifold sight shield (2) to the bracket (1).
- Tighten the intake manifold sight shield bolt (3).
Tighten
Tighten the intake manifold sight shield bolt to 10 N.m (89 lb in).
Use care when installing the engine sight shield to avoid contacting the manifold absolute pressure (MAP) sensor wire harness connector. Loss of engine performance or engine damage may result.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.