Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2001 Chevrolet Suburban C1500SECTION Installation Procedure
WARNING: This page is about a different car, the 2001 GMC Sierra and 2001 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Install the accelerator pedal.
- Install the end bushings to the pivot shaft.
- Install the end bushing retaining clips.
- Install the accelerator cable through the slot in the accelerator pedal lever (2).
- Seat the retainer (3) in the accelerator pedal lever (2).
- Check for complete throttle opening and closing positions by operating the accelerator pedal. Also check for poor carpet fit under the accelerator pedal. The throttle should operate freely without bind between full closed throttle and wide open throttle.
- Install the left instrument panel insulator.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.