Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2001 Chevrolet Suburban C1500SECTION Installation Procedure
WARNING: This page is about a different car, the 2001 GMC Sierra and 2001 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Install the accelerator cable through the bulkhead. Snap the accelerator cable cover tangs (1) through the dash panel.
- Install the accelerator cable through the slot in the accelerator pedal lever.
- Seat the retainer (3) in the accelerator pedal lever (2).
- Install left instrument panel insulator.
- Install the accelerator cable to the engine cable bracket.
- Install the accelerator cable to the throttle body lever.
- Install the accelerator cable to the cable routing bracket.
- Install the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator Replacement .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.