Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2001 Chevrolet Suburban C1500SECTION Installation Procedure
WARNING: This page is about a different car, the 2001 GMC C3500 HD and 2001 Chevrolet C3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Install the injection lines at the pump. Refer to Fuel System Description .
- Uncap the lines and pump fittings.
- Refer to the tags for the correct installation.
- Install the injection lines at the nozzles.
- Uncap the lines and the nozzles.
Tighten: Tighten the fittings to 25 N.m (18 lb ft).
- Install the injection line clips at the loom brackets.
- Remove the J 39664 manifold cover set. See Special Tools .
- Install the intake manifold. Refer to Intake Manifold Installation - Lower) and Intake Manifold Installation - Upper) in Engine Mechanical - 6.5L.
- Install the negative battery cables.
NOTE:
Refer to Fastener Notice in Cautions and Notices.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.