Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
- Install the battery insulator, if necessary.
- Install the battery.
Refer to FASTENER NOTICE in Cautions and Notices.
- Install the battery hold down retainer and bolt.
Tighten
Tighten the battery hold down retainer bolt to 25 N.m (18 lb ft).
- Install the front end diagonal brace and bolts.
Tighten
Tighten the front end diagonal brace bolts to 9 N.m (80 lb in).
- Connect the positive battery cable.
Tighten
Tighten the positive battery cable bolt to 17 N.m (13 lb ft).
- Snap the positive battery cable cap closed.
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Single Battery) .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.