Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2001 Chevrolet Suburban C1500SECTION Installation Procedure
- Refer to FASTENER NOTICE
in Cautions and Notices.
Install the negative battery cable.
- Install the bolt anchoring the negative battery cable to the block.
Tighten
Tighten the bolt to 16 N.m (12 lb ft).
- Install the bolt anchoring the negative battery cable to the frame.
Tighten
Tighten the bolt to 9 N.m (80 lb in).
- Install the negative cable to the power steering accessory bracket (4WD 15 series).
- Remove the safety stands.
- Lower the vehicle.
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Single Battery) .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.