Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2001 Chevrolet Suburban C1500SECTION Installation Procedure
- Install the power outlets to the end panel, if equipped.
- Install the console floor lamp, if equipped. Refer to Console Lamp Replacement in Lighting Systems.
- Install the rear seat audio controls, if equipped. Refer to Rear Seat Audio Control Replacement in Entertainment.
- Install the rear seat heater switch, if equipped. Refer to Rear Seat Heater Switch Replacement in Seats.
- Connect all electrical connectors.
- Install the end panel to the console.
- Refer to FASTENER NOTICE
in Cautions and Notices.
Install the 2 top retaining screws (1).
Tighten
Tighten the screws to 1.6 N.m (14 lb in).
- Install the 4 retaining screws (1).
Tighten
Tighten the screws to 1.6 N.m (14 lb in).
- Install the rear cupholder to the end panel. Refer to Front Floor Console Cup Holder Replacement .
- Install the storage bin. Refer to Front Floor Console Compartment Replacement (Non-Luxury) .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.