Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001SUBURBAN C1500REPAIR AND DIAGNOSISELECTRICALINSTRUMENT PANEL SYSTEM DISPLAYS, GAUGES AND CONSOLEREPAIR INSTRUCTIONSASHTRAY REPLACEMENTINSTALLATION PROCEDURE
2001 Chevrolet Suburban C1500
Installation Procedure
2001 Chevrolet Suburban C1500SECTION Installation Procedure
- Install the ashtray housing to the lower IP trim panel.
- Refer to FASTENER NOTICE
in Cautions and Notices.
Install the screws holding the ashtray housing to the rear of the IP lower trim panel.
Tighten
Tighten the ashtray housing screws to 2 N.m (18 lb in).
- Connect the ashtray lamp wiring harness to the ashtray housing.
- Install the lower IP trim panel. Refer to Instrument Panel Lower Trim Panel Replacement .
- Insert the ashtray to the IP by depressing the tab and sliding the ashtray forward.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.