Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001SUBURBAN C1500REPAIR AND DIAGNOSISBODY & FRAMESEATSPOWER SEAT SYSTEMCOMPONENT LOCATORPOWER SEAT CONNECTOR END VIEWSMEMORY SEAT MODULE - C3
2001 Chevrolet Suburban C1500
Memory Seat Module - C3
2001 Chevrolet Suburban C1500SECTION Memory Seat Module - C3
Memory Seat Module - C3
| Connector Part Information |
|
||
|---|---|---|---|
| Pin | Wire Color | Circuit No. | Function |
| A1 | LT BLU | 1521 | Power Seat Rear Vertical Down Switch Signal |
| A2 | YEL | 1519 | Power Seat Rear Vertical Up Switch Signal |
| A3 | LT GRN | 1523 | Power Seat Horizontal Rearward Switch Signal |
| A4 | TAN | 1522 | Power Seat Horizontal Forward Switch Signal |
| A5 | DK BLU | 1520 | Power Seat Front Vertical Down Switch Signal |
| A6 | DK GRN | 1518 | Power Seat Front Vertical Up Switch Signal |
| A7 | GRY/BLK | 1269 | Power Seat Recline Forward Switch Signal |
| A8 | DK GRN/WHT | 1270 | Power Seat Recline Rearward Switch Signal |
| B1 | LT GRN/BLK | 584 | A/T Shift Lock Control Switch Supply Voltage |
| B2 | BRN | 541 | Ignition 3 Voltage |
| B3 | ORN | 1540 | Battery Positive Voltage |
| B4 B5 | - | - | Not Used |
| B6 | ORN | 614 | Memory Seat Set Switch Signal |
| B7 | WHT | 615 | Memory 1 Switch Signal |
| B8 | PPL | 616 | Memory 2 Switch Signal |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.