Installation Procedure

2001 Chevrolet Suburban C1500SECTION Installation Procedure
    Fig 1: View Of Rear Fog Lamp Lens & Retaining Screws
    GM674724Courtesy of GENERAL MOTORS COMPANY
  1. Install the bulb to the rear fog lamp assembly by inserting the bulb and twisting the bulb clockwise.
  2. Refer to Fastener Notice .

    Install the rear fog lamp lens (1) retaining screws (2).

    TightenΒ 

    Tighten the screws (2) to 2 N.m (18 lb in).

  3. Inspect the operation of the rear fog lamp.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.