Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
2001 Chevrolet Suburban C1500SECTION Removal Procedure
- Ensure the headlamp switch is in the OFF position.
- Remove the upper garnish molding at the headliner. Refer to Rear Upper Garnish Molding Replacement (Tahoe/Yukon/Escalade/Suburban) in Interior Trim.
- Remove the right and left side rear window garnish molding.
- Lower the rear of the headliner in order to access the electrical connector.
- Disconnect the electrical connector (4).
- Attach a short piece of wire to the high mounted stop lamp connector in order to assist the guiding of the harness through the body.
- Remove the high mounted stop lamp screws (2).
- Remove the high mounted stop lamp (1) from the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.