Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Rear Integration Module (RIM) Programming
Prior to replacing RIM, note vehicle personalization features. To set or change features, install scan tool. Turn ignition switch to ON position, engine off. Under CHASSIS MAIN MENU, select Rear Integration Module (RIM). Under RIM Main Menu, select RECALIBRATION. Follow scan tool on screen instructions to recalibrate automatic level control. Perform vehicle personalization to reset owner's desired personalization settings.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.