SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001S10 PICKUP 2D PICKUP, 2.2 5, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 867 (HEATING, VENTILATION AND AIR CONDITIONING)REPAIR INSTRUCTIONSDEFROSTER DUCT REPLACEMENT - WINDSHIELDINSTALLATION PROCEDURE
2001 Chevrolet S10 Pickup 2D Pickup, 2.2 5, Automatic

Installation Procedure

2001 Chevrolet S10 Pickup 2D Pickup, 2.2 5, AutomaticSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Defroster Duct & Retainer
    GM932519Courtesy of GENERAL MOTORS CORP.
  1. Inspect the windshield defrost duct seals. If damaged, replace using Kent Industries adhesive back foam tape P/N 46485 or equivalent.
  2. Install the windshield defrost duct to the HVAC module.
    3. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the windshield defrost duct nuts to the HVAC module.

    Tighten:  Tighten the nuts to 2.5 N.m (22 lb in).

  4. Install the instrument panel upper trim panel. Refer to Trim Panel Replacement - Instrument Panel (I/P) Upper in Instrument Panel, Gages, and Console.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.