Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2001S10 PICKUP 2D PICKUP, 2.2 5, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 754 (HEATING, VENTILATION AND AIR CONDITIONING)REPAIR INSTRUCTIONSRECIRCULATION DOOR REPLACEMENTINSTALLATION PROCEDURE

2001 Chevrolet S10 Pickup 2D Pickup, 2.2 5, Automatic

Installation Procedure

2001 Chevrolet S10 Pickup 2D Pickup, 2.2 5, AutomaticSECTION Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Install the recirculation door into the recirculation housing.
Install the recirculation actuator.

Fig 1: Recirculation Actuator Vacuum Hose

Courtesy of GENERAL MOTORS CORP.

Install the recirculation housing to the HVAC module.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the recirculation housing screws.
Tighten: Tighten the screws to 1.6 N.m (14 lb in).
Connect the recirculation actuator vacuum hose.
Install the SIR bracket. Refer to Bracket Replacement - SIR in Instrument Panel, Gages and Console.
Install the I/P trim pad. Refer to Trim Pad Replacement - Instrument Panel (I/P) Upper in Instrument Panel, Gages and Console.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.