SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001S10 PICKUP 2D PICKUP, 2.2 5, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 754 (HEATING, VENTILATION AND AIR CONDITIONING)REPAIR INSTRUCTIONSDEFROSTER DOOR REPLACEMENTINSTALLATION PROCEDURE
2001 Chevrolet S10 Pickup 2D Pickup, 2.2 5, Automatic

Installation Procedure

2001 Chevrolet S10 Pickup 2D Pickup, 2.2 5, AutomaticSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Air Distribution Case Cover & Retaining Screws
    GM395301Courtesy of GENERAL MOTORS CORP.
  1. Install the defroster door.
  2. Connect the linkage between the air temperature door and the heater door.
  3. Install a new air distribution case seal
  4. Install the air distribution case cover.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the air distributor case cover retaining screws.

    Tighten:  Tighten the screws to 1.6 N.m (14 lb in).

  6. Install the defroster door vacuum actuator.
  7. Install the I/P trim pad. Refer to Trim Pad Replacement - Instrument Panel (I/P) Upper in Instrument Panel, Gages and Console.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.