Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001S10 PICKUP 2D PICKUP, 2.2 5, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 754 (HEATING, VENTILATION AND AIR CONDITIONING)REPAIR INSTRUCTIONSCOMPRESSOR REPLACEMENTINSTALLATION PROCEDURE
2001 Chevrolet S10 Pickup 2D Pickup, 2.2 5, Automatic
Installation Procedure
2001 Chevrolet S10 Pickup 2D Pickup, 2.2 5, AutomaticSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Install the compressor mounting stud to the compressor.
- Install the compressor into position on the compressor mounting bracket.
- Install the compressor mounting stud to the engine block.
- Install the upper compressor mounting bolt.
- Install the lower compressor mounting bolts.
NOTE:
Refer to Fastener Notice in Cautions and Notices.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.