Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2001S10 PICKUP 2D PICKUP, 2.2 5, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 754 (HEATING, VENTILATION AND AIR CONDITIONING)REPAIR INSTRUCTIONSCOMPRESSOR MOUNTING BRACKET REPLACEMENTINSTALLATION PROCEDURE

2001 Chevrolet S10 Pickup 2D Pickup, 2.2 5, Automatic

Installation Procedure

2001 Chevrolet S10 Pickup 2D Pickup, 2.2 5, AutomaticSECTION Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Engine Block Compressor Mounting Bracket & Stud

Courtesy of GENERAL MOTORS CORP.

Install the compressor mounting stud to the engine block.
Install the compressor mounting bracket onto the compressor mounting stud.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the compressor bracket mounting bolt.
Tighten: Tighten the bolt to 50 N.m (37 lb ft).

Fig 2: Compressor Drive Belt Tensioner & Compressor Mounting Bracket

Courtesy of GENERAL MOTORS CORP.

Install the compressor drive belt idler pulley to the compressor mounting bracket.
Tighten: Tighten the compressor drive belt idler pulley to 50 N.m (37 lb ft).
Install the compressor drive belt tensioner to the compressor mounting bracket.
Tighten: Tighten the compressor drive belt tensioner to 25 N.m (18 lb ft).
Install the compressor. Refer to Compressor Replacement .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.