Compressor Control Valve Assembly Removal (V7 - Direct Mount)

2001 Chevrolet S10 Pickup 2D Pickup, 2.2 5, AutomaticSECTION Compressor Control Valve Assembly Removal (V7 - Direct Mount)
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required 

J 41790-A  A/C Compressor Holding Fixture. See Special Tools and Equipment .

    Fig 1: View Of Compressor Mounting Fixture
    GM157595Courtesy of GENERAL MOTORS CORP.
  1. Remove the A/C compressor from the vehicle.
  2. Clamp the J 41790-A  in a vise and attach the A/C compressor to the J 41790-A  . See Special Tools and Equipment .
  3. Fig 2: A/C Compressor Control Valve & Retaining Ring
    GM214740Courtesy of GENERAL MOTORS CORP.
  4. Using internal snap ring pliers, remove the A/C compressor control valve retaining ring.
  5. Remove the A/C compressor control valve from the A/C compressor.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.