Steering Column Trim Covers: Installation

2001 Chevrolet Impala PoliceSECTION Installation
  1. Install the upper trim cover (2) onto the steering column. Screw the 2 Torx(R) head screws (1) into the upper trim cover (2). Tighten the 2 Torx(R) head screws to 13 INCH lbs. (1.5 N.m). See Fig 4 .
  2. Install the lower trim cover onto the upper trim cover. Match the tab slots on the lower trim cover with the locking tabs on the upper trim cover. See Fig 3 .
  3. Tilt the lower trim cover up. Slide the lower trim cover forward until the locking tabs snap into the tab slots. Screw the 2 Torx(R) head screws (1) into the lower trim cover (2). Tighten the 2 Torx(R) head screws to 31 INCH lbs. (3.5 N.m). See Fig 2 .
  4. Install the tilt lever. See Fig 1 . Install the steering wheel. See appropriate STEERING COLUMNS article in STEERING. Enable the SIR system. See AIR BAG DEACTIVATION PROCEDURES article in GENERAL INFORMATION.
Fig 1: Removing & Installing Tilt Lever
G00078293Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.