Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC P0325: Knock Sensor Module Circuit: Description
Knock Sensors (KS) produce an AC signal under all engine operating conditions. Powertrain Control Module (PCM) calculates average voltage range of each knock sensors signal. If KS system is operating normally, PCM should monitor KS signal voltage varying more than and less than calculated average range. DTC sets when PCM malfunctions in a manner which will not allow proper diagnosis of KS system.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.