2001 Chevrolet Cutaway 6.5 FFACTORY OEM SERVICE PROCEDURE

Powertrain Control Module

  1. After replacing PCM or if program needs to be updated, refer to latest Techline® information on PCM reprogramming.
  2. After vehicle has been programmed, operate vehicle until coolant temperature is greater than 170°F (77°C). PCM will automatically activate the TDC offset program. If PCM is not programmed with a TDC offset, DTC P1214 will set. See DTC P1214 .
  3. After reprogramming PCM, perform THEFT DETERRENT SYSTEM PROGRAMMING  and GLOW PLUG SYSTEM RELEARN PROCEDURE  .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.