Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Chevrolet Cutaway 6.5 FFACTORY OEM SERVICE PROCEDURE
Glow Plug System Relearn Procedure
NOTE:
Glow plug system type learn is used to identify the correct system type (Federal or California). If a system type has not been relearned after PCM has been flashed, DTC P0380 will set.
- Turn ignition on, with engine off.
- Using scan tool, select "Special Functions, Engine Output Functions" and "Glow Plug System Learn".
- Activate "Glow Plug System Learn" by selecting ON. After learn function has been preformed, NOT LEARNED will be displayed on scan tool. In this step, scan tool is clearing system type.
- Using scan tool, select "Special Functions" menu, and select "Glow Plug".
- Activate "Glow Plug" system by selecting ON. In this step, glow plug relay is now sending the identifying (signature) voltage to PCM.
- PCM will now be able to identify correct glow plug system type. For visual verification of glow plug system, refer to glow plug controller, located on top rear of engine.
- Using scan tool, clear DTC P0380.
- Allow PCM to power down for at least 45 seconds.
- Turn ignition on, with engine off. Using scan tool, verify that DTC P0380 has not reset. If DTC P0380 resets, go to next step.
- Check connections at glow plug relay. Repeat relearn procedures. If relearn fails again, diagnose using DTC P0380 test. Go to DTC P0380Β .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
