Electrical Component Locator: Motors

2001 Chevrolet Corvette Base, 2D Convertible, StandardSECTION Motors
MOTORS LOCATION

Component Location
Blower Motor Under right side of dash.
Door Lock Actuator (2) In respective door.
Electric Actuator (Left/Right) On respective side of HVAC module.
Engine Cooling Fan Motor (Left) Behind left side of radiator.
Engine Cooling Fan Motor (Right) Behind right side of radiator.
Fuel Pump W/Left Fuel Level Sensor In fuel tank.
Fuel Tank Filler Door Lock Actuator On left side of cargo compartment, above fuel filler door.
Headlamp Opening Door Assembly (2) Behind respective headlamp assembly.
Magnasteer Actuator On left side of steering gear.
Power Seat Motor (3) Under each seat.
Power Window Motor (2) In lower section of each door.
Radio Power Antenna (Convertible) Behind right rear inner quarter panel trim.
Rear Compartment Lid Latch Actuator (Convertible/Hardtop) On center rear of rear compartment, on latch.
Rear Compartment Lid Latch Actuator (Coupe) (Left) On left rear of rear compartment, on latch.
Rear Compartment Lid Latch Actuator (Coupe) (Right) On right rear of rear compartment, on latch.
Secondary Air Injection (AIR) Pump Motor On left front of engine compartment, on skid bar.
Telescoping Drive Motor On lower right side of steering column.
Temperature Door Motor On left side of HVAC module.
Throttle Actuator Control (TAC) Motor On left side of throttle body. See Figure .
Variable Effort Steering (VES) Actuator On left side of steering rack assembly.
Windshield Washer Pump Motor On left rear of engine compartment, in washer fluid reservoir.
Windshield Wiper Motor On left side of firewall.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.