Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CORVETTE BASE, 2D CONVERTIBLE, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESTRACTION CONTROLANTI-LOCK BRAKE SYSTEM WITH TRACTION CONTROL SYSTEMBLEEDING BRAKE SYSTEMPRESSURE BLEEDING PROCEDURE
2001 Chevrolet Corvette Base, 2D Convertible, Standard
Pressure Bleeding Procedure
2001 Chevrolet Corvette Base, 2D Convertible, StandardSECTION Pressure Bleeding Procedure
- Install Bleeder Adapter (J-35589-A) to brake master cylinder. Pressurize bleeder to 25-30 psi (1.76-2.11 kg/cm2 ). Connect bleeder hose to adapter, and bleed air from adapter.
- Raise and support vehicle. Starting at right rear wheel, place proper size box end wrench over bleeder valve. Attach one end of clear tube over valve and submerge other end in container partially filled with clean brake fluid.
- Loosen bleeder valve at least 3/4 turn to purge air from cylinder. Tighten bleeder valve when air is no longer present in tube. Repeat sequence until all air is removed.
- Remove tube and wrench. Proceed to left front, then left rear and finish at right front wheel. Remove bleeder adapter. Fill master cylinder, and install cover. Ensure there is no sponginess in brake pedal and that BRAKE warning light is off.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.