Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC P1381: Misfire Detected - No Communication With Brake Control Module: Description
Powertrain Control Module (PCM) detects engine misfire by detecting variations in crankshaft deceleration between firing strokes. For accurate detection of engine misfire, PCM must be able to distinguish between crankshaft deceleration caused by actual misfire or deceleration caused by rough road conditions.
ABS can detect if vehicle is on a rough road based on wheel acceleration/deceleration data supplied by wheel speed sensors. If ABS system detects rough road above a predetermined threshold, this information is sent to PCM via serial data. PCM can then take rough road into account when calculating misfire. Even if ABS is malfunctioning and cannot detect rough roads, misfire diagnostic will continue to run. However, if a misfire DTC is set, this additional DTC will also set indicating that rough road data was not available during misfire calculation due to serial data malfunction.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.