SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G3500, VAN PASSENGER EXTENDED, 6.5 FREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 777 (LIGHTING SYSTEMS)DIAGNOSTIC INFORMATION AND PROCEDURESSCAN TOOL DATA DEFINITIONSOUTPUTS
2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 F

Scan Tool Data Definitions: Outputs

2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 FSECTION Outputs
WARNING: This page is about a different car, the 2003 Buick Regal and 2003 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.

Backup Lamp Relay:  The scan tool displays ON/OFF. This output of the BCM is displayed as ON when the backup lamps are turned on.

Front Fog Lamp Relay:  The scan tool displays ON/OFF. This output of the BCM is displayed as ON when the fog lamps are turned on.

Headlamps:  The scan tool displays ON/OFF. This output of the BCM is displayed as ON, if the BCM commands the headlamps ON.

Inadvertent Power Output:  The scan tool displays OFF or ON. When the BCM is not commanding the inadvertent power On, the scan tool will display Off. When the BCM is commanding the inadvertent power ON, the scan tool will display ON.

Left Turn Signal:  The scan tool displays ON/OFF. This output of the BCM is displayed as ON, if the turn signal switch is activated in the turn left position.

Park Lamps:  The scan tool displays Off or On. When the BCM is not commanding the park lamp relay On, the scan tool will display Off. When the BCM is commanding the park lamp relay On, the scan tool will display On.

Right Turn Signal:  The scan tool displays ON/OFF. This output of the BCM is displayed as ON, if the turn signal switch is activated in the turn right position.

Theater Dimming #1:  The scan tool displays OFF or On. When the BCM is not commanding the theater dimming ON, the scan tool displays OFF. When the BCM is commanding the theater dimming ON the scan tool displays ON.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.