Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G3500, VAN PASSENGER EXTENDED, 6.5 FREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 716 (SEAT SYSTEM)REPAIR INSTRUCTIONSSEAT BACK RELEASE CABLE REPLACEMENT - FRONTREMOVAL PROCEDURE

2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 F

Removal Procedure

2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 FSECTION Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Seat Cushion Frame To Adjuster Bolts

Courtesy of GENERAL MOTORS CORP.

Remove the seat back trim cover. Refer to Seat Back Cover and Pad Replacement - Front (RPO AR9 Base Seat) .
Remove the seat back free play retention cable from the rear of the seat back (passenger seat only).

Fig 2: Actuators Underneath Seat Frame Springs

Courtesy of GENERAL MOTORS CORP.

Push down on the seat cushion to expose the hinge bolt nuts.
Remove the right and left hinge bolt nuts.
Remove the release cables from the hinge bolts.

Fig 3: Bezel At Release Lever To Bezel Locking Tabs

Courtesy of GENERAL MOTORS CORP.

Remove the release cable mechanism from the upper seat back by depressing the taps and pushing the release lever out of the seat back frame.
Remove the bezel from the release lever by spreading the bezel locking tabs.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.