Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G3500, VAN PASSENGER EXTENDED, 6.5 FREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 704 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSFOG LAMP REPLACEMENT - FRONTINSTALLATION PROCEDURE

2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 F

Installation Procedure

2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 FSECTION Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Fog Lamp To Front Bumper Impact Bar

Courtesy of GENERAL MOTORS CORP.

Position the front fog lamp to the front bumper impact bar.
Insert the fog lamp bracket alignment tab into the hole on the front bumper impact bar.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the front fog lamp mounting bolt to the front bumper impact bar.
Tighten: Tighten the front fog lamp mounting bolt to 2 N.m (18 lb in).

Fig 2: Front Fog Lamp Electrical Connector To Fog Lamp Bulb/Socket

Courtesy of GENERAL MOTORS CORP.

Connect the front fog lamp electrical connector to the fog lamp bulb/socket.

Fig 3: Brake Caliper Cooling Duct To Front Fascia

Courtesy of GENERAL MOTORS CORP.

Position the brake caliper cooling duct to the front fascia, and press to secure.
Install the front fascia lower close out panel. Refer to Close Out Panel - Front Bumper Fascia Lower in Bumpers.
Lower the vehicle.
Check and adjust fog lamp aim as necessary. Refer to Fog Lamp Aiming Procedure .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.