SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G3500, VAN PASSENGER EXTENDED, 6.5 FREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 704 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSBACKUP LAMP REPLACEMENTINSTALLATION PROCEDURE
2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 F

Installation Procedure

2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 FSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Backup Lamp Assembly To Vehicle
    GM64620Courtesy of GENERAL MOTORS CORP.
  1. Install the backup lamp sockets to the backup lamp assembly.

    Rotate the sockets clockwise to engage the locking tabs.

  2. Install the backup lamp assembly into position on the vehicle.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the backup lamp assembly retaining screws.

    Tighten:  Tighten the backup lamp and rear license assembly retaining screws to 2 N.m (18 lb in).

  4. Install the rear license plate.
  5. Install the rear license frame.

    Align the locking tabs, then press engage.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.