Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G3500, VAN PASSENGER EXTENDED, 6.5 FREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 687 (BODY FRONT END)REPAIR INSTRUCTIONSHOOD LATCH SUPPORT REPLACEMENTINSTALLATION PROCEDURE
2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 F
Installation Procedure
2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 FSECTION Installation Procedure
WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
- Position the hood latch support to the upper and lower tie bar.NOTE: Refer to FASTENER NOTICE .
- Install the to the hood latch support to upper tie bar bolts.
Tighten
Tighten the hood latch support upper tie bar bolts to 25 N.m (18 lb ft).
- Install the hood latch support to lower tie bar nut.
Tighten
Tighten the hood latch support to lower tie bar nut to 10 N.m (89 lb in).
- Install the hood latch to the hood latch support Refer to Hood Latch Replacement .
- Install the front bumper fascia upper support to the hood latch support. Refer to FASCIA SUPPORT REPLACEMENT -- FRONT BUMPER UPPER .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.