Installation Procedure

2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 FSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the hood latch release cable to the hood latch.
    Fig 1: Connecting Hood Latch Release Cable To Hood Latch
    G01503966Courtesy of GENERAL MOTORS CORP.
  2. Position the hood latch to the marks on the hood latch support bracket.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the hood latch to center support bracket bolts.

    TightenΒ 

    Tighten the hood latch to center support bracket bolts to 25 N.m (18 lbft).

  4. Adjust the hood as required. Refer to HOOD ADJUSTMENTΒ  .
  5. Close the hood.
    Fig 2: Installing Hood Latch To Center Support Bracket And Bolts
    G01503967Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.