Installation Procedure

2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 FSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the cruise control module on the shock tower mounting studs.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the cruise control module retaining nuts.

    Tighten 

    Tighten the cruise control module to shock tower nuts to 2 N.m (18 lb in).

    Fig 1: Installing Cruise Control Module Retaining Nuts
    G01503795Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical connector to the cruise control module.
  4. Install the cruise control cable to the cruise control module. Refer to CRUISE CONTROL CABLE REPLACEMENT (3.1L)  or CRUISE CONTROL CABLE REPLACEMENT (3.8L)  .
    Fig 2: Installing Cruise Control Cable To Cruise Control Module
    G01503796Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.